Orca Bay - 1/18/12

OK - so I adjusted the needle position on my Lexus/Lily -
3 clicks to the right - 5.0 -
Better be Should be enough to compensate for that elusive 1/8” -

But -

This making ONE block at a time -
Is waaaaaaaaaaaaaaaaay slow -
I’m never going to catch up at this rate -
I know that it's NOT a race - but even still - ;))

I’m going to try to do this assembly line -

So I sorted the QST -

Fiddle - fiddle - TRY NOT to get the same black or white in the same set of four -

OK - that’s it -
If any of these suckers match -
Too bad - ;))

Talk to you later - gotta go - gotta so -