FROM BEHIND CUTTING TABLE
Back side of the cutting table - you can see the other door and the drawer that holds my rulers - the 10-drawer unit holds finished blocks and the squares I cut from my scraps. I just push the cutting table around if I want more room.
DESIGN WALL AND IRONING BOARD
Design Wall - a piece of felt thumb-tacked to the back-side of the angled/wonky wall. It's empty in the photo because I was "between" projects. I'm left-handed so I put the pointy end of the ironing board on the left to hold the iron - I move the whole thing to the other side of the room when I'm playing around with block layouts. Sometimes when the window is open, a nice breeze will blow the blocks off the wall - that's always fun!
Talk to you later – gotta go – gotta sew –
5 comments:
Wait...so if I use my ironing board that way, I'm using it left-handed? I KNEW I did more in lefty than tying my shoes!
Your sewing room looks so tidy...are you sure you're a quilter? Mine hasn't looked that tidy since the day I moved in and I'm doubting it looked that good even then!
Katie -
Not necessarily. I don't know if pointing the ironing board that way is left or right-handed. If you iron shirts - it's probably right-handed - so you can get to the narrow parts of the shirt. But since I don't DO shirts - I use the pointy end for my iron.
So - righties - how do you set up your iron and ironing board? Katie and I are curious.
And these photos were taken when I had cleaned up and was "between" projects. You should see it when I'm in the "middle" of one!!
^..^
Well, where else would the pointy end of the ironing board go?
I put the pointy end of my ironing board to the left, too - and I'm right handed. Katie M.
Katie M. -
Thanks, Katie. I think that if I actually "used" the pointy end - for anything other than an "iron holder" - I would put it to the right.
^..^
Post a Comment